Whether you are running a tire dealership or a customer wants to get new set of tires installed, either way – your success depends upon the correct tire mounting and balancing. For sure, the customers get happy and satisfied when they find that the new set of tires has been installed in the perfect way using the right mounting and balancing techniques. On the flip side, there are a few newbies that end up making a few mistakes unknowingly.

car-tires

Therefore, we’ve highlighted a few major mistakes that people make while mounting and balancing tires. So let’s dive in;

Failure to Recognize the TPMS

First of all, make sure that you recognize the tire pressure monitoring system. Furthermore, must pay attention to what type of TPMS is installed on the vehicle. In case the sensor is at the valve, it has the potential to get damaged. Ensure that the TPMS sensors are working perfectly before servicing any vehicle. Otherwise, you might end up facing the customer accusation that you damaged their TPMS during mounting.

Improper Handling of Reverse Mount Wheels

As we all know, the reverse mount wheels are extremely common. In fact, the giants of this industry recommend using a reverse mount adaptor just to avoid scratching the wheel’s surface. And also because the Scratches on a chrome rim will turn into rust. It’s better to use the jaw protection to avoid any damage while clamping. Many tire changers will even give you specs for outside clamping as well.

Not Using Enough Lubrication

Whether you are mounting the tires or removing, it’s imperative to use the required amount of lubrication. This is one of the essential steps of car tyre fitting. In fact, using too much lubrication or incorrect solution can cause slippage and vibration problems. On the flip side, too little lube can cause damage to the tire and wheel.

If you use the incorrect lubricants, it will create long-term wheel corrosion, leakage & premature failures. Therefore, ensure to lube the inner toe area of the tire bead, bead seat and balcony of wheel drop center.

Incorrect Mounting after Balancing the Assembly

You are still quite likely to make a mistake once the assembly is off the balancer. Simply, put the assembly back on the wheel. It’s essential to torque assembly to manufacturers’ specs. Variation in a lug nut torque is a major cause of vibration. In case you use consistent torque, it will eliminate a few variables that are likely to cause a comeback. The proper maintenance of equipment is critical to correct mounting & balancing.

Outside Coning

This is one of the major balancing mistakes that must be avoided. According to the experts, the use of outside cones leads to wobbling & run-out. They recommend that one should place a cone on the back of the assembly and then apply for the correct-size plate simply by centering it on the lug holes. Ensure that you mount and center the assembly, in the same manner, it’ll be mounted & balanced on the vehicle.

Summary

Do you want to learn more about mistakes that people make with mounting and balancing tires? Just check out the article now